BLS For Electric Scooters/Chairs
The BLS will rejuvenate old lead-acid batteries that are used in electric scooters or electric chairs. The most common model used for aircraft’s is the BLS-12/24B. You can install the BLS permanently to the batteries and use the system as normal, the BLS will gradually rejuvenate the batteries and keep them in an optimal condition.
Rejuvenating and Maintaining Electric Scooter/Chairs Batteries
You will need:
- BLS-12/24B
- 12 or 24 volt Battery Charger (2 to 10 amps)
- Daily timer (optional)
Step 1:
Test for a Bad Battery: The BLS cannot recover a battery with a short or open cell. To test for this, please visit this page.
Step 2:
Attach the BLS and fully charge the battery or batteries.
Step 3:
Disconnect of turn of the charger, leaving the BLS attached. Let the BLS slowly drain the batteries for 10 to 18 hours (you can attach a small load, like a light bulb, to drain the batteries).
Step 4:
Repeat Steps 2 & 3 until the battery reaches optimal condition or when the battery is ready for use.
BLS Models:
BLS-12/24B |
 |
For 12 and 24 volt battery systems. Also ideal for use with a battery charger to rejuvenate unusable batteries. Comes with alligator type battery clips for attachment. This is the best BLS model to rejuvenate old batteries.
12 Volt BatterySolver Package |
 |
Storage solution for 12 volt batteries. It is also an automatic solution to rejuvenate old “dead” batteries. Connect the BLS and the charger to the battery . Plug the charger into the timer, and set the timer to turn on once a day for 4 hours. This will rejuvenate your battery and keep it in optimal condition. Includes BLS-12/24B, the VEC080(12 volt, 2 amp Float Charger) and an indoor timer.
